This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › General v
Can't program KNX devices via SpaceLynk

Linear Mode
Can't program KNX devices via SpaceLynk
frankyy Offline
Junior Member
Posts: 4
Threads: 0
Joined: Oct 2017
Reputation: 0
#22
25.01.2022, 13:19
I changed to 500 and restarted but the LM still sends the MemoryExtended_Write (S=8) after and then the Zennio device disconnects.
Find
Reply


Messages In This Thread
RE: Can't program KNX devices via SpaceLynk - by frankyy - 25.01.2022, 13:19

Forum Jump: