This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
LogicMachine Forum › LogicMachine eco-system › General v
Problem with remote KNX programming on port 3671

Linear Mode
Problem with remote KNX programming on port 3671
Dan22 Offline
Junior Member
Posts: 11
Threads: 2
Joined: Mar 2016
Reputation: 0
#20
16.02.2022, 17:13 (This post was last modified: 16.02.2022, 17:43 by Dan22.)
I haven't tried zero tier, there is a guaranteed guide somewhere, I would not like to go to LM at the customer's
Daniel,
Thanks for the advice, ZT works.
Find
Reply


Messages In This Thread
RE: Problem with remote KNX programming on port 3671 - by Dan22 - 16.02.2022, 17:13

Forum Jump: