Hello,
I have a Wiser for KNX with a strange problem:
basically we have 18 devices all in a line (no coupler), everything was powered but with a line scan we can't see pretty much any device at all...sometimes 2 or 3 of them (and never the same devices) popping out and then disappear again if we run another line scan.
This is probably a bus problem, we tried to remove some devices and pretty much anything changed.
On the error log I have
I deleted the errors but there were more and they keeps repeating.
Locally, if I move for example a setpoint, everything works fine...the system turn on all the other devices as if the bus have no problems.
I'm really confused...
I have a Wiser for KNX with a strange problem:
basically we have 18 devices all in a line (no coupler), everything was powered but with a line scan we can't see pretty much any device at all...sometimes 2 or 3 of them (and never the same devices) popping out and then disappear again if we run another line scan.
This is probably a bus problem, we tried to remove some devices and pretty much anything changed.
On the error log I have
I deleted the errors but there were more and they keeps repeating.
Locally, if I move for example a setpoint, everything works fine...the system turn on all the other devices as if the bus have no problems.
I'm really confused...