28.11.2016, 18:04
(This post was last modified: 29.11.2016, 07:39 by gjniewenhuijse.)
We have a lot of fibaro motion sensors connected to a LM4. Every motion detection packet is sended to the lm4 and every 15 minutes a temperature packet.
After restarting the lm4 we see the following behaviour:
- motion sensor detection packets and temperature packets did not received by the lm4 for 2 hours (the motion sensor wakeup interval is 7200), is that normal behaviour?
after two hours every motion detection packet is received and every 15 minutes a temperature packet.
- all devices parameters are reset to default in the lm4, not in the zwave device self. How can we get the current device parameters in the lm4 and not the default?
After restarting the lm4 we see the following behaviour:
- motion sensor detection packets and temperature packets did not received by the lm4 for 2 hours (the motion sensor wakeup interval is 7200), is that normal behaviour?
after two hours every motion detection packet is received and every 15 minutes a temperature packet.
- all devices parameters are reset to default in the lm4, not in the zwave device self. How can we get the current device parameters in the lm4 and not the default?