10.12.2016, 15:24
Hello,
I have multiple Modbus slaves with various supported baud rates that I want to connect but due to the look of the RTU settings panel in the web interface, it seems that on LM4, only one of the 3 RS-485 ports can be used for Modbus RTU.
I have a pellet heater gateway that only supports 9600 baud, Schneider meters than supports from 9600 to 38400 baud and Embedded Systems Universal IO-20 that supports only 115200 baud.
How can I interface all these devices to the LM4 ? Is it possible to use an additional RS-485 port for Modbus RTU ?
I have multiple Modbus slaves with various supported baud rates that I want to connect but due to the look of the RTU settings panel in the web interface, it seems that on LM4, only one of the 3 RS-485 ports can be used for Modbus RTU.
I have a pellet heater gateway that only supports 9600 baud, Schneider meters than supports from 9600 to 38400 baud and Embedded Systems Universal IO-20 that supports only 115200 baud.
How can I interface all these devices to the LM4 ? Is it possible to use an additional RS-485 port for Modbus RTU ?