05.10.2022, 12:06
(This post was last modified: 05.10.2022, 12:10 by manos@dynamitec.)
Hello Daniel,
Thank you for the quick response.
Yes this will be just in LM all done via virtual objects. No need to send any data over the KNX TP.
So if I understand correctly all the following ports can be used for modbus rtu communication.
I have read that 700m in general is the max lenght for a modbus line including the brunches (could be extended with repeaters but its not the point).
But this can change according to the interface hardware (LM), cable type, baud rate...
Would 500m lenght be still ok for LM to handle if baud is set to 9600?
Thank you again for the great support and effort.
Thank you for the quick response.
Yes this will be just in LM all done via virtual objects. No need to send any data over the KNX TP.
So if I understand correctly all the following ports can be used for modbus rtu communication.
I have read that 700m in general is the max lenght for a modbus line including the brunches (could be extended with repeaters but its not the point).
But this can change according to the interface hardware (LM), cable type, baud rate...
Would 500m lenght be still ok for LM to handle if baud is set to 9600?
Thank you again for the great support and effort.