Zigbee gateway integration

[tigi]

Hi,

I'm trying to add the Tuya ZMS01 PIR Detector but for some reason it's not working.
I am able to add the device, a profile is connected to it (260) and the log shows a change when movement is detected (ZoneStatus goes from 0 to 1).

However I see nothing happen in the monitor nor do I see the attached group address change when movement is detected.
I'm wondering if a new profile needs to be created for this appliance or if I'm doing something wrong?
Also attached is the logging when joining.

I was able to fetch som more data, however I'm not able to see it all because of 'nesting too deep'.
Is there a way to see all data transmitted?

Code:

* table:
["cluster"]
  * number: 0
["linkquality"]
  * number: 78
["group"]
  * number: 0
["direction"]
  * string: RX
["from"]
  * string: a4c1388ff0df6591
["srcep"]
  * number: 1
["data"]
  * table:
   ["FrameControl"]
    * table:
     [1]
      * string: FrameTypeGlobal
     [2]
      * string: DirectionFromServer
     [3]
      * string: DisableDefaultResponse
   ["TransactionSequenceNumber"]
    * number: 1
   ["GeneralCommandFrame"]
    * table:
     ["CommandIdentifier"]
      * string: ReadAttributesResponse
     ["ReadAttributesResponse"]
      * table:
       ["ReadAttributeStatusRecords"]
        * table:
         [1]
          * table:
           ["AttributeIdentifier"]
            * number: 3
           ["Status"]
            * string: SUCCESS
           ["Attribute"]
            * table:
             nesting too deep
         [2]
          * table:
           ["AttributeIdentifier"]
            * number: 4
           ["Status"]
            * string: SUCCESS
           ["Attribute"]
            * table:
             nesting too deep
         [3]
          * table:
           ["AttributeIdentifier"]
            * number: 5
           ["Status"]
            * string: SUCCESS
           ["Attribute"]
            * table:
             nesting too deep