Hello together,
I had the following problem today..:
At a customer I wanted to program new line couplers, these are equipped with KNX secure.
When I then tried to program them via the controller LM5 the following error message was displayed in the ETS 6: Programming failed. This operation requires an APDU length of 34 bytes, there are only 15 available due to the possibilities of the bus interface. Is there a possibility to increase this APDU length or is this bus interface not able to perform this programming?
Other devices can be programmed without problems.
I had the following problem today..:
At a customer I wanted to program new line couplers, these are equipped with KNX secure.
When I then tried to program them via the controller LM5 the following error message was displayed in the ETS 6: Programming failed. This operation requires an APDU length of 34 bytes, there are only 15 available due to the possibilities of the bus interface. Is there a possibility to increase this APDU length or is this bus interface not able to perform this programming?
Other devices can be programmed without problems.