KNX Problems with programming KNX Secure

Linear Mode

KNX Problems with programming KNX Secure

manos@dynamitec Offline

Member

Posts: 133
Threads: 19
Joined: Apr 2018
Reputation: 0

23.03.2023, 09:15 (This post was last modified: 23.03.2023, 09:15 by manos@dynamitec.)

(22.03.2023, 13:09)admin Wrote: You need to upgrade the firmware for the KNX long frame support.

Hello Admin,

I have the same problem with two different sites.

One site using LM5Lp2 (FW. 20211215), failed multiple times downloading a Zennio Z41 touch pannel. Here remote access via ZeroTier.
The other site using HomeLynk V2.7.0, failed multiple times to download Jung 230021 SU modules. Here remote access via IPSec VPN provided from the client.

What is the solution to this?

Regards,

Find

« Next Oldest | Next Newest »

Messages In This Thread

KNX Problems with programming KNX Secure - by F.Braun - 22.03.2023, 12:51

RE: KNX Problems with programming KNX Secure - by admin - 22.03.2023, 12:52

RE: KNX Problems with programming KNX Secure - by F.Braun - 22.03.2023, 13:06

RE: KNX Problems with programming KNX Secure - by admin - 22.03.2023, 13:09

RE: KNX Problems with programming KNX Secure - by manos@dynamitec - 23.03.2023, 09:15

RE: KNX Problems with programming KNX Secure - by F.Braun - 23.03.2023, 10:18

RE: KNX Problems with programming KNX Secure - by admin - 24.03.2023, 08:49

RE: KNX Problems with programming KNX Secure - by manos@dynamitec - 24.03.2023, 11:49

RE: KNX Problems with programming KNX Secure - by manos@dynamitec - 24.03.2023, 17:09