This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
LogicMachine Forum › LogicMachine eco-system › Gateway v
KNX Problems with programming KNX Secure

Linear Mode
KNX Problems with programming KNX Secure
F.Braun Offline
Junior Member
Posts: 8
Threads: 4
Joined: Jan 2023
Reputation: 0
#6
23.03.2023, 10:18
(22.03.2023, 13:09)admin Wrote: You need to upgrade the firmware for the KNX long frame support.

I have installed the update on a test controller and can now program everything again. Thank you very much. I will test the solution soon at the customers site.
Find
Reply


Messages In This Thread
RE: KNX Problems with programming KNX Secure - by F.Braun - 23.03.2023, 10:18

Forum Jump: