This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › CANx v
Trouble after power failure

Linear Mode
Trouble after power failure
aicanx Offline
Junior Member
Posts: 7
Threads: 2
Joined: May 2023
Reputation: 0
#1
18.05.2023, 08:04
Hi admin!
The project I have uses a Canx UIO16 device. After power failure and reboot, the group addresses are not controllable, I have to Write Configuration of the UIO16 device to be able to control the group addresses.
Thank you in advance!
Find
Reply


Messages In This Thread
Trouble after power failure - by aicanx - 18.05.2023, 08:04
RE: Trouble after power failure - by Daniel - 18.05.2023, 10:19
RE: Trouble after power failure - by aicanx - 18.05.2023, 11:08
RE: Trouble after power failure - by Daniel - 18.05.2023, 12:18
RE: Trouble after power failure - by aicanx - 19.05.2023, 08:46
RE: Trouble after power failure - by Daniel - 19.05.2023, 08:50
RE: Trouble after power failure - by aicanx - 19.05.2023, 10:53
RE: Trouble after power failure - by hoangknx - 12.06.2023, 07:09
RE: Trouble after power failure - by Daniel - 12.06.2023, 07:28
RE: Trouble after power failure - by admin - 12.06.2023, 13:30

Forum Jump: