23.01.2017, 15:35
Hello, i have new door/window sensors and the same problem. But it looks like it has something todo with the include procedure. If i do the following steps it works for me:
- activate battery
- close sensor case
- set lm4 to include
- push the button on the bottom of the sensor 3 times (quick)
- wait for minimal 1 minute so all parameters are transfered (if you do not, then some parameters are missing and excluding of the sensor crashed the zwave deamon).
- activate battery
- close sensor case
- set lm4 to include
- push the button on the bottom of the sensor 3 times (quick)
- wait for minimal 1 minute so all parameters are transfered (if you do not, then some parameters are missing and excluding of the sensor crashed the zwave deamon).