13.09.2023, 10:57
Hi at all,
I'm studying the ZigBee library, because I have a problem with a ZigBee device (his firmware it is bagged). The device sends status if the CMD arrives from LM but if I made changed in local, it doesn't send messages.
If I press the read command on the ZigBee interface status arrive. (See attached picture)
Here my request, is it possible by script simulate the pressing of that button?
Or which is the function in the library to request the device status?
Best regards Cristian
I'm studying the ZigBee library, because I have a problem with a ZigBee device (his firmware it is bagged). The device sends status if the CMD arrives from LM but if I made changed in local, it doesn't send messages.
If I press the read command on the ZigBee interface status arrive. (See attached picture)
Here my request, is it possible by script simulate the pressing of that button?
Or which is the function in the library to request the device status?
Best regards Cristian