This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › General v
Restore Settings on Power Up into KNX System

Linear Mode
Restore Settings on Power Up into KNX System
admin Offline
Administrator
Posts: 7758
Threads: 42
Joined: Jun 2015
Reputation: 447
#7
05.03.2024, 06:10
You can simply use a 230V relay connected to a KNX binary input to monitor external power. Clearing storage is needed. Otherwise if LM is rebooted for any other reason than UPS power loss then old thermostat values will be restored.
Find
Reply


Messages In This Thread
RE: Restore Settings on Power Up into KNX System - by admin - 05.03.2024, 06:10

Forum Jump: