This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Gateway v
CPU I/O High Load when using Modbus RTU

Linear Mode
CPU I/O High Load when using Modbus RTU
jmir Offline
Member
Posts: 242
Threads: 56
Joined: Sep 2015
Reputation: 0
#3
14.03.2024, 11:40 (This post was last modified: 14.03.2024, 11:45 by jmir.)
About 20 registers on each slave and I use value delta.

Profiles have more than 20 registers but most of them are not mapped to KNX (devices are input/output modules and I've generic profiles and i'm mapping only what I need)

I've noticed
Find
Reply


Messages In This Thread
RE: CPU I/O High Load when using Modbus RTU - by jmir - 14.03.2024, 11:40

Forum Jump: