This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

LM - "IP Tunneling" "IP Routing" and "Multicast IP"
#2
The Mode defines how LM is connecting to KNX. If you select tunneling it means this LM is connected via another interface to TP and the locally connected TP is ignored.
TP-uart is a default mode with the TP and routing enabled. Routing mode is then just routing enabled but TP disabled.

Use TP-uart mode on all and in ETS you may need to use NAT if going from another Vlan

You can also use Zerotier and do it via cloud.
------------------------------
Ctrl+F5
Reply


Messages In This Thread
RE: LM - "IP Tunneling" "IP Routing" and "Multicast IP" - by Daniel - 05.04.2024, 12:56

Forum Jump: