27.08.2024, 10:21
Thank you Daniel!
I decided to start with client app, installed it. After scan I found my device. Than I start device reading. Takes time a little, but in result I found 2384 different parameters with different types... Is it too much for app? What does mean priorities in device? Can I change value of point or it depends device? And I think better mostly to use virtual groups not to create big KNX load..
What you can advise?
Alex
I decided to start with client app, installed it. After scan I found my device. Than I start device reading. Takes time a little, but in result I found 2384 different parameters with different types... Is it too much for app? What does mean priorities in device? Can I change value of point or it depends device? And I think better mostly to use virtual groups not to create big KNX load..
What you can advise?
Alex