This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Gateway v
Programming KNX via LM

Poll: Have you experienced similar problems?
You do not have permission to vote in this poll.
No! My projects are <50 devices.
25.00%
 3 25.00%
Yes! My projects are <50 devices.
16.67%
 2 16.67%
No! My projects are >50 devices.
25.00%
 3 25.00%
Yes! My projects are >50 devices.
33.33%
 4 33.33%
Total 12 vote(s) 100%
* You voted for this item. [Show Results]

Linear Mode
Programming KNX via LM
Krstfr Offline
Junior Member
Posts: 13
Threads: 5
Joined: Dec 2016
Reputation: 0
#8
28.02.2017, 10:48
Zennio products are somewhat different than other products, always use "Partial Download", if you don't it always downloads a firmware update which takes from 5 to 15 minutes for each product.
Find
Reply


Messages In This Thread
Programming KNX via LM - by zoltan - 27.02.2017, 14:09
RE: Programming KNX via LM - by zoltan - 27.02.2017, 14:58
RE: Programming KNX via LM - by Habib - 27.02.2017, 20:24
RE: Programming KNX via LM - by Krstfr - 28.02.2017, 05:59
RE: Programming KNX via LM - by zoltan - 28.02.2017, 07:43
RE: Programming KNX via LM - by FatMax - 28.02.2017, 08:10
RE: Programming KNX via LM - by Krstfr - 28.02.2017, 10:48

Forum Jump: