This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Gateway v
Modbus stops working after

Linear Mode
Modbus stops working after
AlexD Offline
Junior Member
Posts: 14
Threads: 2
Joined: Jul 2020
Reputation: 0
#5
07.10.2024, 08:32
Seems to be the same result. It works for a less then a minute after I save the RTU settings, then the same error occure. Poll intervall i sat to 15 seconds and timeout 0,5 seconds. Is there anything I should change here? I have done some tests without that solving anything. Or maybe I should change the delay time in the profile higher then 0.1s?
Find
Reply


Messages In This Thread
Modbus stops working after - by AlexD - 05.10.2024, 17:53
RE: Modbus stops working after - by admin - 07.10.2024, 06:35
RE: Modbus stops working after - by AlexD - 07.10.2024, 07:13
RE: Modbus stops working after - by admin - 07.10.2024, 07:16
RE: Modbus stops working after - by AlexD - 07.10.2024, 08:32
RE: Modbus stops working after - by admin - 07.10.2024, 08:34
RE: Modbus stops working after - by AlexD - 07.10.2024, 08:53
RE: Modbus stops working after - by admin - 07.10.2024, 09:05

Forum Jump: