My Cbus SHAC has died, suspect it was during a lightning storm but other iot devices attached to my 24v power supply are still working fine.
After opening up the case to trace the power supply on the board I have found what looks likely to be the issue.
L2 (L2 is on the negative 24v power supply rail) in the picture looks to be damaged, anyone know what this is? Any electrical guru or board designer have any input on how to test this surface mount component?
Surely there is a chance that replacing 1 component and she will power up again, at a cost of $1500aud surely it's worth fixing or at least trying.
I tried to upload a picture but it's too large, ive shrunk it down so it will upload.
After opening up the case to trace the power supply on the board I have found what looks likely to be the issue.
L2 (L2 is on the negative 24v power supply rail) in the picture looks to be damaged, anyone know what this is? Any electrical guru or board designer have any input on how to test this surface mount component?
Surely there is a chance that replacing 1 component and she will power up again, at a cost of $1500aud surely it's worth fixing or at least trying.
I tried to upload a picture but it's too large, ive shrunk it down so it will upload.