Zigbee gateway integration

[stianj]

@stianj, enable debug logging in ZigBee app then reset and pair your lamp again. Send the logs afterwards.

Thanks. Logs attached. I enabled debug logging, deleted the bulb from the app, reset the bulb, opened the network, re-joined the bulb, configured all the GA's, then turned it on and off and changed brightness using the GA's.

The bulb in question has address 001788010b270b60

But result is still the same, the status GA's do not update unless I use "Read" on the Control and status page. This goes for all six Hue bulbs I have.

I can't quite see I'm doing anything wrong here, but I'm very open to you proving me otherwise