This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Gateway v
Issue Writing Setpoint on Modbus Device (PLOGIC)

Linear Mode
Issue Writing Setpoint on Modbus Device (PLOGIC)
Gadjoken Offline
Member
Posts: 90
Threads: 17
Joined: Jun 2016
Reputation: 2
#3
30.04.2025, 08:17
Hello Daniel,
Yes indeed, addresses 1102 and 1103 must be set to 1, which I do, but two seconds later they revert to 0 and it's impossible to write the setpoint value.
This doesn't happen when writing the registers via Modbus Doctor
Find
Reply


Messages In This Thread
RE: Issue Writing Setpoint on Modbus Device (PLOGIC) - by Gadjoken - 30.04.2025, 08:17

Forum Jump: