This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Gateway v
1-wire sensor management

Linear Mode
1-wire sensor management
a455115 Offline
Member
Posts: 101
Threads: 16
Joined: Aug 2019
Reputation: 0
#7
Yesterday, 15:04
I’m experiencing the same issue, but my sensors are from the 28h family (DS18B20), which should be fully supported according to the posts above. The ID address shows up in the 1-Wire tab, but no current value is displayed. Any suggestions?    
Find
Reply


Messages In This Thread
1-wire sensor management - by raunz - 06.11.2015, 10:51
RE: 1-wire sensor management - by admin - 06.11.2015, 11:54
RE: 1-wire sensor management - by Jørn - 19.09.2016, 16:33
RE: 1-wire sensor management - by admin - 20.09.2016, 06:19
RE: 1-wire sensor management - by andeug - 10.10.2016, 14:24
RE: 1-wire sensor management - by admin - 10.10.2016, 16:50
RE: 1-wire sensor management - by a455115 - Yesterday, 15:04
RE: 1-wire sensor management - by admin - Yesterday, 15:07
RE: 1-wire sensor management - by a455115 - Yesterday, 16:26
RE: 1-wire sensor management - by admin - Yesterday, 16:27
RE: 1-wire sensor management - by a455115 - Yesterday, 16:32
RE: 1-wire sensor management - by admin - Yesterday, 16:35
RE: 1-wire sensor management - by a455115 - Yesterday, 16:42
RE: 1-wire sensor management - by admin - Yesterday, 16:51
RE: 1-wire sensor management - by a455115 - Yesterday, 17:02
RE: 1-wire sensor management - by a455115 - Yesterday, 18:07

Forum Jump: