(Yesterday, 15:07)admin Wrote: Have you tried mapping sensors to objects?
Yes, the sensors are already mapped to objects (as shown in the configuration popup). However, the current value is still not displayed in the 1-Wire tab.
|
1-wire sensor management
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
1-wire sensor management - by raunz - 06.11.2015, 10:51
RE: 1-wire sensor management - by admin - 06.11.2015, 11:54
RE: 1-wire sensor management - by Jørn - 19.09.2016, 16:33
RE: 1-wire sensor management - by admin - 20.09.2016, 06:19
RE: 1-wire sensor management - by andeug - 10.10.2016, 14:24
RE: 1-wire sensor management - by admin - 10.10.2016, 16:50
RE: 1-wire sensor management - by a455115 - Yesterday, 15:04
RE: 1-wire sensor management - by admin - Yesterday, 15:07
RE: 1-wire sensor management - by a455115 - Yesterday, 16:26
RE: 1-wire sensor management - by admin - Yesterday, 16:27
RE: 1-wire sensor management - by a455115 - Yesterday, 16:32
RE: 1-wire sensor management - by admin - Yesterday, 16:35
RE: 1-wire sensor management - by a455115 - Yesterday, 16:42
RE: 1-wire sensor management - by admin - Yesterday, 16:51
RE: 1-wire sensor management - by a455115 - Yesterday, 17:02
RE: 1-wire sensor management - by a455115 - Yesterday, 18:07
|