05.06.2025, 04:03
(This post was last modified: 05.06.2025, 04:08 by Erwin van der Zwart.)
I guess all 25 “mini projects” are just a duplicate and i assume every room uses the same group addresses? If that is the case than you need to redo everything to bring it together on KNX side or you need a controller in each separate room..
There are tools (ets apps) that could help you to do this, i believe it’s called something like extended copy from KNX Org itself, there you can duplicate devices and set an offset in the addresses
There are tools (ets apps) that could help you to do this, i believe it’s called something like extended copy from KNX Org itself, there you can duplicate devices and set an offset in the addresses