I encounter a number of problems with my Z-wave components, but before all, I noticed quite an increase in CPU load after starting the daemon.
As can be seen on the attached screenshot, the normal load on my LM4 is around 0,3, but when I start the daemon, the CPU load rises to more than 1,3.
Is this to be considered as normal?
Thanks.
Edit: Right after posting this message, I stopped the daemon. The load went back to normal, but the daemon stated again "automatically", I did not start i up manually. I tried to stop it a second time and it did, but after a few seconds it restarted...
The good news is that the load does not increase anymore. Mystery...
In another message I will post some other things I encountered which I can't figure out.
As can be seen on the attached screenshot, the normal load on my LM4 is around 0,3, but when I start the daemon, the CPU load rises to more than 1,3.
Is this to be considered as normal?
Thanks.
Edit: Right after posting this message, I stopped the daemon. The load went back to normal, but the daemon stated again "automatically", I did not start i up manually. I tried to stop it a second time and it did, but after a few seconds it restarted...
The good news is that the load does not increase anymore. Mystery...
In another message I will post some other things I encountered which I can't figure out.