Zwave - Fibaro Motion Sensor

[baggins]

baggins, how many devices are connected? Are you writing all Zwave sensor update data into KNX bus as well?
Is Zwave USB stick blinking?

hi edgars, you replied wile I updated my post above...
As can be seen above, the load is back to normal. I write nothing to the bus. The stick is not blinking.

The whole story so far:
I have an Aeotec Z-Stick S2 and 2 Aeotec ZW074 MultiSensor Gen5.

Initially I connected this to my LM4, but couldn't get it to work. As I have no knowledge on Z-wave devices I decided to do a simple test and hooked everything up to a raspberry running Home Assistant. That worked quite well: I did not have to do anything and both sensors  showed results, values were updated, etc.

Now that I was sure that the components were OK, I reconnected the stick to LM4.

Since the sensors were already paired with the stick, I assumed that this would remain so, but only one was listed. The one that is listed showed correct values for the moment I connected the stick, but the values are not updated. I did not change anything to the settings of the sensor apart from assigning an address and data type.


So, do I have to pair the other sensor (or both) again and do I have to change something to the settings of the sensors to receive updates?

Thanks.