30.03.2017, 06:37
Good morning,
I have two seperate KNX installations and i need to merge them into one.
First project consist of three lines (1.1, 1.2, 1.3) and have group address from 0/xx/xxx to 5/xx/xxx. On main line sits a Logic Machine Load Balancer that connects to the KNX bus with a IP interface.
Second project consist of one line (1.10) and have group address 10/xx/xxx and i am using Logic Machine reactor V2 direct conected on the TP line.
The goal is to have all 4 lines and all group addresses under a single project and use Load Balancer for visualization and scripting and Reactor V2 for gateway and redundancy.
Can someone suggest the most eficient way to achive the merge?
Thank you in advance
George
I have two seperate KNX installations and i need to merge them into one.
First project consist of three lines (1.1, 1.2, 1.3) and have group address from 0/xx/xxx to 5/xx/xxx. On main line sits a Logic Machine Load Balancer that connects to the KNX bus with a IP interface.
Second project consist of one line (1.10) and have group address 10/xx/xxx and i am using Logic Machine reactor V2 direct conected on the TP line.
The goal is to have all 4 lines and all group addresses under a single project and use Load Balancer for visualization and scripting and Reactor V2 for gateway and redundancy.
Can someone suggest the most eficient way to achive the merge?
Thank you in advance
George