Fallo recuperacion Backup

[Tofolmp]

Backup is restored via LogicMachine - Utilities - Restore.

Thank you for your reply.
Just to confirm, the correct procedure would be:

1. Reset the LogicMachine to factory defaults (if needed).
   
2. Update firmware and signature to match the original device (if required).
   
3. Restore the backup from LogicMachine → Utilities → Restore.
   

Is that correct?
Additionally, when restoring the backup using this method, is the entire system configuration also restored?
For example: IP settings, ZeroTier configuration, KNX gateway settings, etc.
Finally, is it mandatory to match the firmware/signature version before restoring the backup, or can it be restored on a newer version?
Thank you for your help and patience, as we are beginners with this device and we do not yet fully master it.