27.03.2026, 09:15
Nice AI report, of course they would blame us 
Anyway, tested a similar setup with two LMs:
- LM 1 is connected to TP bus
- LM 2 is connected to LM 1 via IP tunnel
- ETS connected to LM 1 via IP tunnel
IP routing is disabled on both LMs to prevent potential loops. Programming KNX device application works fine, no extra telegrams in ETS group monitor.
Anyway, tested a similar setup with two LMs:
- LM 1 is connected to TP bus
- LM 2 is connected to LM 1 via IP tunnel
- ETS connected to LM 1 via IP tunnel
IP routing is disabled on both LMs to prevent potential loops. Programming KNX device application works fine, no extra telegrams in ETS group monitor.