7 hours ago
Hi !
We are using a Spacelynk to read a lot of variables (140) from a Schneider PLC with a profile json.
If I set the poll interval between 1 and 5 seconds, the CPU is very overloaded and everything seems to be slow:
It only gets better (less than 1.0) with more than 6-7 seconds. But I need a faster polling rate for this application.
The profile is communicating fine with the PLC.
Any idea how can we overcome this issue ?
I attach the json used
We are using a Spacelynk to read a lot of variables (140) from a Schneider PLC with a profile json.
If I set the poll interval between 1 and 5 seconds, the CPU is very overloaded and everything seems to be slow:
It only gets better (less than 1.0) with more than 6-7 seconds. But I need a faster polling rate for this application.
The profile is communicating fine with the PLC.
Any idea how can we overcome this issue ?
I attach the json used