05.08.2026, 08:24
When there is a offset between setpoint control and setpoint status +/- buttons do not work as intended.
example: KNX thermostat with local offset control set to -3 degrees.
setpoint control = 20 degrees
setpoint status = 17 degrees
If you use the +/- buttons adjusting 0.5 degreens up it seems like ut tries to adjust to 17.5 which results in setpoint control writing 17.5 to the bus and setpoint status goes to 14.5.
solution: option to choose whether +/- buttons use status or control for input ?
When working with KNX thermostats with relative setpoint offset as in this example it would be great if we can show two setpoint arcs in different colours so no 'jumping' of setpoint occurs.
example: KNX thermostat with local offset control set to -3 degrees.
setpoint control = 20 degrees
setpoint status = 17 degrees
If you use the +/- buttons adjusting 0.5 degreens up it seems like ut tries to adjust to 17.5 which results in setpoint control writing 17.5 to the bus and setpoint status goes to 14.5.
solution: option to choose whether +/- buttons use status or control for input ?
When working with KNX thermostats with relative setpoint offset as in this example it would be great if we can show two setpoint arcs in different colours so no 'jumping' of setpoint occurs.