After some fidgeting, I managed to get my two Aeotoec Multisensors to be recognized.
For both multisensors I assigned a group address to a couple of sensor objects (temperature and relative humidity).
As I wanted to create some graphs, I marked these addresses to be logged. When I noted that the graphs would not be created I found out that the log of these objects would appear only briefly in the Object Logs and then they vanish from the log!
What my be the reason for this?
Update:
Could this be related to the fact that the Obect log was at full capacity? This was already the case for some time, but I -probably erroneously- assumed that the oldest values would be discarded.
I have now cleared the object log and up to now the values seem to remain in the log and show up in the graphs...
For both multisensors I assigned a group address to a couple of sensor objects (temperature and relative humidity).
As I wanted to create some graphs, I marked these addresses to be logged. When I noted that the graphs would not be created I found out that the log of these objects would appear only briefly in the Object Logs and then they vanish from the log!
What my be the reason for this?
Update:
Could this be related to the fact that the Obect log was at full capacity? This was already the case for some time, but I -probably erroneously- assumed that the oldest values would be discarded.
I have now cleared the object log and up to now the values seem to remain in the log and show up in the graphs...