31.05.2017, 18:16
Hi everyone,
I have a problem with analog output of LM3.
When I set 0V for Ao, I check with V.O.M that I receive voltage is 0.3V not 0V.
So, these lights (controlled) with driver 0-10V not OFF. Can you check with your LM.
I have to use 1sw to off these lights.
I hope can you check these Ao of LM.
Thank you so much
I have a problem with analog output of LM3.
When I set 0V for Ao, I check with V.O.M that I receive voltage is 0.3V not 0V.
So, these lights (controlled) with driver 0-10V not OFF. Can you check with your LM.
I have to use 1sw to off these lights.
I hope can you check these Ao of LM.
Thank you so much