Analog Output 0-10V

[nhieulk]

Hi everyone,

I have a problem with analog output of LM3.

When I set 0V for Ao, I check with V.O.M that I receive voltage is 0.3V not 0V.

So, these lights (controlled) with driver 0-10V not OFF. Can you check with your LM.

I have to use 1sw to off these lights.

I hope can you check these Ao of LM.

Thank you so much

There was no AO on LM3. if you mean lm3 Reactor, unfortunatly 0.3V is minimum voltage for that device/

Yes, LM3 reactor

---

Yes, there's an issue with some devices with 0-10V input where it does not turn off.
LM5 reactors have different analog output schematics and this issue is fixed.

Thank you so much