I'm trying to connect through USB because whenever I'm connected through IP I simply can't upload to 2 exact DALI actuators. The rest of the actuators (like 30 more) are okay, it's just these two DALI ones. Error says that the device is not responding but it's already connected and it dims lights too. I wanted to troubleshoot this and connect via USB.
It seems like when I literally spam the button "test", once a few minutes (like 10) it says Ok but as soon as I press test again it goes back to either KNX Interface not found or Device did not respond in time. It switches between these two errors.
It seems like when I literally spam the button "test", once a few minutes (like 10) it says Ok but as soon as I press test again it goes back to either KNX Interface not found or Device did not respond in time. It switches between these two errors.