10.02.2018, 15:57
Hello i have problem in Visualization.
When I have button for light control (main object is 1bit ,stasus object is 1bit signal from Actuator rele feedback) in case i try push button directly from editor, everything works fine, toogle works 0 1 0 1 0 1, but when i use same visualization directly over web page toogle sending only 0 0 0 0 0 so light never goes on...
Where is the problem?
Thank you
When I have button for light control (main object is 1bit ,stasus object is 1bit signal from Actuator rele feedback) in case i try push button directly from editor, everything works fine, toogle works 0 1 0 1 0 1, but when i use same visualization directly over web page toogle sending only 0 0 0 0 0 so light never goes on...
Where is the problem?
Thank you