knx/tp error

Linear Mode

knx/tp error

Daniel Offline

Administrator

Posts: 4833
Threads: 25
Joined: Aug 2017
Reputation: 220

01.03.2018, 10:33

(01.03.2018, 10:14)Gabi Wrote: Hi
Logic Machine 3, Firmware 20150917.

OK old one. Can you open it and check what is written on KNX chip? In this LM it will be Siemens and version can be 5.2 or 5.3.

------------------------------
Ctrl+F5

Find

« Next Oldest | Next Newest »

Messages In This Thread

knx/tp error - by Gabi - 28.02.2018, 07:54

RE: knx/tp error - by Daniel - 28.02.2018, 10:03

RE: knx/tp error - by Gabi - 01.03.2018, 10:14

RE: knx/tp error - by Daniel - 01.03.2018, 10:33

RE: knx/tp error - by AEK - 01.03.2018, 11:47

RE: knx/tp error - by Gabi - 02.03.2018, 04:01

RE: knx/tp error - by Daniel - 02.03.2018, 09:51

RE: knx/tp error - by Gabi - 12.03.2018, 05:15

RE: knx/tp error - by Daniel - 12.03.2018, 08:31

RE: knx/tp error - by Gabi - 20.03.2018, 08:59

RE: knx/tp error - by Gabi - 22.03.2018, 07:08

RE: knx/tp error - by Daniel - 22.03.2018, 09:32

RE: knx/tp error - by Gabi - 27.03.2018, 05:21

RE: knx/tp error - by edgars - 27.03.2018, 06:33

RE: knx/tp error - by DGrandes - 26.10.2020, 07:56

RE: knx/tp error - by Daniel - 26.10.2020, 08:30

RE: knx/tp error - by DGrandes - 27.10.2020, 12:11

RE: knx/tp error - by admin - 27.10.2020, 12:14

RE: knx/tp error - by DGrandes - 29.10.2020, 15:44

RE: knx/tp error - by AlexLV - 27.10.2020, 12:46

RE: knx/tp error - by admin - 27.10.2020, 12:56

RE: knx/tp error - by AlexLV - 27.10.2020, 13:03

RE: knx/tp error - by admin - 10.10.2023, 07:01

RE: knx/tp error - by Daniel - 10.10.2023, 09:26