Hi,
I'm just starting with KNX, and was wondering what would be the best way to control a ceiling Fan motor ? I would like to control the speed of the fan step wise.
Here is what I think is the best approach, but need expert opinion on the same:
1. Connect the ceiling fan with normal leading/trailing edge dimmer.
2. Program the Sensor/key pad to send step dimming to the actuator.
Another way is just to connect the fan to an on/off actuator, but then controlling fan speed would be an issue. I've also seen Fan actuators (not fan coil) available with 3 steps from ABB, but is it required ?
thanks,
Vineet
I'm just starting with KNX, and was wondering what would be the best way to control a ceiling Fan motor ? I would like to control the speed of the fan step wise.
Here is what I think is the best approach, but need expert opinion on the same:
1. Connect the ceiling fan with normal leading/trailing edge dimmer.
2. Program the Sensor/key pad to send step dimming to the actuator.
Another way is just to connect the fan to an on/off actuator, but then controlling fan speed would be an issue. I've also seen Fan actuators (not fan coil) available with 3 steps from ABB, but is it required ?
thanks,
Vineet