31.08.2018, 08:17
Hello,
I tried to start using LM as a router in KNX but I've found problems.
I've connected 2 LMs as a routers: LM Reactor V3 and LM5. Firstly I've tried to use devices with not upgraded version and after current.
2 routers with addresses 1.2.0 (192.168.2.25) and 1.3.0 (192.168.2.23) connected in TP Link Router (192.168.2.1).
In 1.2 line there is only device: 1 input module from Siemens.
In 1.3 line there is also only 1 device: 4in/out analog module from MDT.
I want program firstly addresses but I see no device in programming mode. When I change connection type to TP-UART I see device in programming mode. How should I connect LM or configure it to work as a router?
The same situation is with sending group addresses. When I send value in LM Object tab to device which is connected to the LM and is routed by this LM telegram is not reaching the device but when I change LM mode to TP-UART all works fine and the device sends feedback and output is set to specific value.
I tried to start using LM as a router in KNX but I've found problems.
I've connected 2 LMs as a routers: LM Reactor V3 and LM5. Firstly I've tried to use devices with not upgraded version and after current.
2 routers with addresses 1.2.0 (192.168.2.25) and 1.3.0 (192.168.2.23) connected in TP Link Router (192.168.2.1).
In 1.2 line there is only device: 1 input module from Siemens.
In 1.3 line there is also only 1 device: 4in/out analog module from MDT.
I want program firstly addresses but I see no device in programming mode. When I change connection type to TP-UART I see device in programming mode. How should I connect LM or configure it to work as a router?
The same situation is with sending group addresses. When I send value in LM Object tab to device which is connected to the LM and is routed by this LM telegram is not reaching the device but when I change LM mode to TP-UART all works fine and the device sends feedback and output is set to specific value.
Done is better than perfect