03.09.2018, 06:53
If you have a physical TP connection, set mode to TP-UART. IP features must be enabled for routing and tunneling to work. If you set connection mode to routing or tunneling then LM will just ignore TP completely.
Our security implementation differs from standard KNX (because it's too complex and bloated as most things in KNX world). Tunneling will be disabled if only secure connections are allowed.
If you need to program devices, set mode to TP-UART, keep IP features enabled and connect to each LM directly via tunneling. There's no other way to do this.
Our security implementation differs from standard KNX (because it's too complex and bloated as most things in KNX world). Tunneling will be disabled if only secure connections are allowed.
If you need to program devices, set mode to TP-UART, keep IP features enabled and connect to each LM directly via tunneling. There's no other way to do this.