08.07.2021, 11:36
(08.07.2021, 11:34)admin Wrote: The different between write and update is that write will send a telegram to KNX/TP (if connected). Since TP bus is slow it's recommended not to send data that is not needed. There's no difference between write and update for virtual objects.
Setting of groups should be done once, ballast will store this data internally. You cannot get group status, only single ballast status.
thank you adminĀ
clear
but could you clarify this: "but keep in mind that you will lose status values for each ballast if using DALI groups"
Best Regards,