This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

CanX UIO8 analog input
#8
(26.04.2019, 11:01)edgars Wrote: Hi Kai,
we have made another device for resistive sensor inputs. For current UIO8 this isn't possible because our inputs are non-potential. In case of PT1000 we need to have internal pull-up resistor (with very good precision, no more than 0.1%) and voltage source for pull-up. That's why we made separate device for this functionality. 

By the way, why NTC is preferable and not PT1000?

Hi.

I understand. I'm just a little pampered with some of the products i normally use :)
NTC is just becouse we use have a lot of these since we use them on different KNX products.

Here is an example of a product i see as compact and extremely versatile (excuse my Paint layout). It fits in resident installations like a glove.
If it was possible to make somthing like this with CanX and LoRa antenna, then the word would not need any other products! With a Clip for mounting on DIN rail, one product would be enough in all cases. Almost  ;)

   
Reply


Messages In This Thread
CanX UIO8 analog input - by Kai-Roger - 11.04.2019, 19:31
RE: CanX UIO8 analog input - by AEK - 11.04.2019, 19:46
RE: CanX UIO8 analog input - by Kai-Roger - 11.04.2019, 19:49
RE: CanX UIO8 analog input - by AEK - 11.04.2019, 19:54
RE: CanX UIO8 analog input - by Kai-Roger - 11.04.2019, 20:12
RE: CanX UIO8 analog input - by Kai-Roger - 26.04.2019, 10:42
RE: CanX UIO8 analog input - by edgars - 26.04.2019, 11:01
RE: CanX UIO8 analog input - by Kai-Roger - 26.04.2019, 11:34

Forum Jump: