22.03.2020, 20:56
I plan to have a spaceLYnk, a "Wiser for KNX" and an LM5 all connected to the same TP line (the main line 1.0.-).
Everything works fine when one unit is connected (the spaceLYnk with lots of scripts), but when I attach the second (Wiser no scripts yet - just approximately 1000 GAs), lots of strange things happen (lights start blinking, scripts are not run, etc). I have a feeling that the system goes into some trashing mode.
Anything I need to adjust in terms of parameters?
For instance, they all have the same "multicast" address. Is that OK?
I have checked that they have different IP addresses (DHCP), so no problem there.
They have TP-UART as mode.
One has KNX Individual address 1.0.240, the other has the default 15.15.250. Is the individual address used for anything?
Any other good tips?
Thanks in advance
Rgds
Christian
Everything works fine when one unit is connected (the spaceLYnk with lots of scripts), but when I attach the second (Wiser no scripts yet - just approximately 1000 GAs), lots of strange things happen (lights start blinking, scripts are not run, etc). I have a feeling that the system goes into some trashing mode.
Anything I need to adjust in terms of parameters?
For instance, they all have the same "multicast" address. Is that OK?
I have checked that they have different IP addresses (DHCP), so no problem there.
They have TP-UART as mode.
One has KNX Individual address 1.0.240, the other has the default 15.15.250. Is the individual address used for anything?
Any other good tips?
Thanks in advance
Rgds
Christian