This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

LM5 and KNX integration - how should you work with programming
#8
(09.11.2020, 13:02)admin Wrote: By default LM is a transparent bridge between KNX/TP and any other protocols. Any group message from KNX/TP will appear in LM and vice versa. For modbus control just make sure that your KNX button and LM Modbus mapping have the same group address. It will work automatically.
Thanks. I think this confirms that I am missing something in ETS5 and I should be able to achieve what I am thinking about. So I need to figure out how to access the group addresses made in LM5 in ETS5...
Reply


Messages In This Thread
RE: LM5 and KNX integration - how should you work with programming - by dreamcatcher - 09.11.2020, 14:22

Forum Jump: