This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

Updated Documentation
#1
Hi 
I am going to implement a LM Lite in my Setup. Actually all is in a planning phase.
This give me some time to prepare. 
I actually did some tests with ETS5 and KNX virtual. I have two questions.
a) Is there a possibility to run LM5 firmware in a VirtualBox/QEMU on a Notebook to use it with KNXvirtual.
b) Regarding the Firmware LM 2020.07 RC3, is there a updated Documentation available?

Regards
Heinz
Reply


Messages In This Thread
Updated Documentation - by hstampfl - 11.11.2020, 17:33
RE: Updated Documentation - by admin - 12.11.2020, 07:33

Forum Jump: