This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.
Logic Machine Forum › LogicMachine eco-system › Gateway v
KNX Problems with programming KNX Secure

Linear Mode
KNX Problems with programming KNX Secure
manos@dynamitec Offline
Member
Posts: 133
Threads: 19
Joined: Apr 2018
Reputation: 0
#12
24.03.2023, 13:02
(24.03.2023, 12:03)Daniel Wrote: Is LM using latest firmware? Everyone else confirm that it solves the issue.

Yes LM is on FW 20230307.

See below the same behaviour with the Z41 lite.

Attached Files Thumbnail(s)
   
Find
Reply


Messages In This Thread
RE: KNX Problems with programming KNX Secure - by manos@dynamitec - 24.03.2023, 13:02

Forum Jump: