This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm that you accept these cookies being set.

two LM in the same installation
#1
Good morning,

I have a configuration question...

In an installation we have a LM, the installation is quite big, once the KNX programming is finished, I have to export a large number of objects to BacnetIP (about 3500 objects approximately).

For this purpose, another LM is going to be installed, as I understand that the maximum number of variables to be exported via BacnetIP is 2000.

How would be the best way to configure the two LM? so that there are no bouncing problems or similar?


Thank you very much!



Albeto R.
Reply


Messages In This Thread
two LM in the same installation - by Alberto.ricof - 01.02.2024, 11:59

Forum Jump: