16.07.2017, 09:24
(This post was last modified: 16.07.2017, 09:24 by Erwin van der Zwart.)
Hi,
You can use our KNX actuators with current detection, they measure the load (by current) on each channel and with this measurement data you know if the load is still consuming power.
There is a lot of logic already in the application of the device and any missing logic you can solve in the LM.
BR,
Erwin
Actuators with current detection.pdf (Size: 1.36 MB / Downloads: 28)
You can use our KNX actuators with current detection, they measure the load (by current) on each channel and with this measurement data you know if the load is still consuming power.
There is a lot of logic already in the application of the device and any missing logic you can solve in the LM.
BR,
Erwin
Actuators with current detection.pdf (Size: 1.36 MB / Downloads: 28)