28.12.2022, 16:59
I am using TOUCH 3 and a standard "Dimmer rotary" in my Wiser for KNX visualisation.
When pressing the middle button (the on/off button), Wiser seems to send BOTH a 1 bit ON/OFF GA and a 1 byte VALUE GA (of either 0% or 100% depending on whether you turn on or off the lamp). Is this really the case? Can I configure this so that the VALUE is not sent?
Needless to say: The VALUE byte should not be sent as this destroys the "previous" DALI value the next the lamp is switched on.
See pictures below.
Thanks in advance
When pressing the middle button (the on/off button), Wiser seems to send BOTH a 1 bit ON/OFF GA and a 1 byte VALUE GA (of either 0% or 100% depending on whether you turn on or off the lamp). Is this really the case? Can I configure this so that the VALUE is not sent?
Needless to say: The VALUE byte should not be sent as this destroys the "previous" DALI value the next the lamp is switched on.
See pictures below.
Thanks in advance